Hi
i working on A20 SOM and i make an interface board to connect ethernet .
how i can enable eth0 on my board ?
my "ifconfig -a"
lo Link encap:Local Loopback
LOOPBACK MTU:16436 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
tunl0 Link encap:IPIP Tunnel HWaddr
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
wlan0 Link encap:Ethernet HWaddr 44:33:4c:80:ce:9a
inet addr:192.168.20.2 Bcast:192.168.255.255 Mask:255.255.0.0
inet6 addr: fe80::4633:4cff:fe80:ce9a/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:77 errors:0 dropped:994 overruns:0 frame:0
TX packets:95 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:9972 (9.7 KiB) TX bytes:11804 (11.5 KiB)
thank you
ok, it's solved.
I just have to enable gmac on my fex
So Now i have a new problem. i can ping other device but i have 30% fail and i cant connect whith ssh .