Print Page - MOD-RFID1356MIFARE single read mode

Title: MOD-RFID1356MIFARE single read mode
Post by: Georg Viertbauer on November 08, 2016, 12:13:09 PM

Hello
I've connected the board over USB CDC.
All works fine ... also setting up the trigger frequency.
Is there a way to set up the scan to single read mode?
The msXX command of the MOD-RFID1356 would be nice.

kr Georg Viertbauer

Title: Re: MOD-RFID1356MIFARE single read mode
Post by: Georg Viertbauer on December 07, 2016, 11:32:00 AM

:( hmmm no replies :(

Title: Re: MOD-RFID1356MIFARE single read mode
Post by: LubOlimex on December 08, 2016, 09:15:32 AM

Hey,

At the moment there is no single read command similar to the msXX one from MOD-RFID1356. There is only mtF command that sets the scan interval.

Thanks for the input, though. The maintainer of the firmware has been notified about this requested feature.

Best regards,
Lub/OLIMEX

Title: Re: MOD-RFID1356MIFARE single read mode
Post by: Georg Viertbauer on December 14, 2016, 10:34:36 AM

Thx a lot

Olimex Support Forum

Others => UEXT => Topic started by: Georg Viertbauer on November 08, 2016, 12:13:09 PM