Print Page - Boot order

Title: Boot order
Post by: aauer1 on February 18, 2013, 12:04:03 AM

Hi

today, I finally got my A13 board running. So, it successfully boots the kernel from the SD card. Now, I would like to try Android. The question is, if I "install" an Android image on the NAND flash, is it still possible to boot from the SD card?
So, in general, what's the boot order of the A13 cpu? MMC1 -> NAND ??

Thanks,
Andreas

Title: Re: Boot order
Post by: mb on February 18, 2013, 12:45:51 AM

That's the behavior of my OLinuXino A13-Wifi board at least.

/Martin

Title: Re: Boot order
Post by: Lurch on February 18, 2013, 12:47:58 AM

There should already be an Android image (VGA) in NAND when shipped. Just take out the bootable SDCard (or replace it with a non-bootable one for you Android data) and it will boot from NAND.

Title: Re: Boot order
Post by: vaishali on February 18, 2013, 08:59:20 AM

yes you are right, the boot sequence is like that only.
If you have connected sd card then it will boot from sd card first.
And if there is nothing in sd card then it will boot from nand.

Title: Re: Boot order
Post by: vaishali on February 25, 2013, 02:48:17 PM

hi aauer1,

i have got boot order for a10 devices.
i think for a13 also the boot order must be same.
here is link http://linux-sunxi.org/Boot

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A13 => Topic started by: aauer1 on February 18, 2013, 12:04:03 AM