Print Page - 'eth0' not listed in nmtui - LIME-2 board and A20-OLinuXino-bullsey OS

Title: 'eth0' not listed in nmtui - LIME-2 board and A20-OLinuXino-bullsey OS
Post by: tejas.s on February 12, 2025, 03:03:03 PM

Board : A20-OLinuXino-LIME2-e16Gs16M

OS : A20-OLinuXino-bullseye-minimal-20241121-172551 and A20-OLinuXino-bullseye-base-20241121-172551

Setup :
I am trying to setup a new olimex board and the OS image(both minimal and base) is prepared on a SD Card.

After completing the bootup the, When I start the Network setup using 'nmtui',
eth0 is not listed under 'Activate a connection'

I have tested with both rev.k and rev.L boards of Lime-2.

Need guidance on how to set static IP Address in nmtui.

Title: Re: 'eth0' not listed in nmtui - LIME-2 board and A20-OLinuXino-bullsey OS
Post by: LubOlimex on February 12, 2025, 04:04:37 PM

Did you frist try "dhclient eth0" or/and "ifup eth0"?

Does the Ethernet work at all? Is it listed in "ifconfig -a"? Are the leds on the Ethernet connector blinking when attached to switch or router?

Olimex Support Forum

OLinuXino Android / Linux boards and System On Modules => A20 => Topic started by: tejas.s on February 12, 2025, 03:03:03 PM