LAN stopped working

[flipflops]

 I was running alarm and everything ran fine for about two weeks, then all of the sudden, the LAN would not come up.

I got a new sd card, configured it to run the olinuxino os and it booted fine with LAN/ssh,etc but it didnt have any OS package manager so I configured the new sd card again but for Alarm's "clean version" but the root fs failed to unpack properly so I configured the new sd card again, this time with Alarm's full version and it comes up, the led blinks, but there is no LAN.

Anybody know what is going on?

[zgyarmati]

Hi flipflops

what does "there is no LAN"? You don't have eth0 device? You cannot reach the device via network?
What could be tricky here, is the fact that the USB-Ethernet chip gets a new MAC address at every boot, so if you connected the board to a router with DHCP configured, most likely it gives a new IP address at every boot to your board...

[flipflops]

I know its an old post but ....

It was a problem with the board. I sent it back to mouser and they replaced it.