MSP430-JTAG-TINY-V2

[dubsy]

Hello all,
I am using the aforementioned Olimex debugger for programming some MSP430 chips in a production environment.  Does anyone have any ideas to allow me to view the checksum onscreen.
The device will be used by untrained personnel and I need the checksum to display (after successful programming) in bold or be highlighted...
Any thoughts would be graciously appreciated.
Thx

[LubOlimex]

Hey dubsy,

Thanks for the post. There is no way to see the checksum.

However there is mechanism to show if the programming went ok or not implemented. If the programming was successful you would have to press the right arrow and if the programming was not successful there would be a message and you would have to press the left arrow.

Best regards,
Lub/OLIMEX