JTAG-TINY-V1 Driver for Windows 10 and IAR Kickstart?

[SKj]

Hallo,

when I connect my JTAG-TINY-V1 to an USB port on my Windows 10 laptop
the JTAG-TINY shows up in the Device manager under the heading "other units".
It says "driver not installed" and I try to update the driver.
Then it says:
A driver was found but a problem occured.
There is no hash value in the catalog file.
The file is probably damaged or manipulated.

I have used the driver recommended in:
https://www.olimex.com/forum/index.php?topic=662.msg2741#msg2741

My questions are:
1. Is this driver supposed to work with Windows 10?
2. If so. How to procced?
3. I also use ICC430. Does that make any difference?

Thank you!
Staffan

[LubOlimex]

Hey,

The driver is not signed. Disable the driver signature enforcement temporarily and then install the driver. The driver installation should work after you have disabled this signature enforcement. There are a lot of guides and videos showing how to disable driver signature enforcement available online.

It seems to work here:



I used the drivers you mentioned.

Best regards,
Lub/OLIMEX

[SKj]

Thank you!

Now it works both in IAR and ICC430.
I followed your advice and it was not enough.
However the IAR Kickstart asked if I wanted to flash the TINY-V1
and after doing that it all worked.

Staffan