≡
Difference between revisions of "How to configure MOD-RTL8188 on official OLinuXino Debian releases"
(Created page with "How to configure MOD-RTL8188 on most official OLinuXino Debian releases: type 'ifconfig -a' and look at your number of the wlan. For instance, we have wlan3 open the file /...") |
|||
(2 intermediate revisions by the same user not shown) | |||
Line 1: | Line 1: | ||
− | |||
− | + | == How to configure MOD-RTL8188 in the official OLinuXino Debian releases == | |
− | |||
− | + | Check the Ethernet and WLAN interfaces by typing: | |
− | + | <nowiki>#ifconfig -a</nowiki> | |
− | and | + | and look at your number of the wlan. For instance, in this example, we have 'wlan3'. Open the file /etc/network/interfaces - for example, by using nano text editor: |
− | <nowiki># | + | <nowiki># nano /etc/network/interfaces</nowiki> |
− | + | It would have a section for wlan3 that looks like shown below: | |
− | wpa-ssid YourSSIDname | + | <nowiki># auto wlan3</nowiki> |
+ | iface wlan3 inet dhcp | ||
+ | wpa-ssid YourSSIDname | ||
+ | wpa-psk YourWPAkey | ||
− | wpa-psk | + | Edit the wpa-ssid and wpa-psk with the values of your network. |
After you are done press 'shift' + 'o' to save. Then press 'shift' + 'x' to exit the nano editor. | After you are done press 'shift' + 'o' to save. Then press 'shift' + 'x' to exit the nano editor. | ||
Line 23: | Line 24: | ||
Then write: | Then write: | ||
− | <nowiki>#ifup wlan3</nowiki> | + | <nowiki># ifup wlan3</nowiki> |
To enable the interface. | To enable the interface. | ||
If the interface doesn't yet start, reboot the board. | If the interface doesn't yet start, reboot the board. |
Latest revision as of 05:13, 24 July 2014
How to configure MOD-RTL8188 in the official OLinuXino Debian releases
Check the Ethernet and WLAN interfaces by typing:
#ifconfig -a
and look at your number of the wlan. For instance, in this example, we have 'wlan3'. Open the file /etc/network/interfaces - for example, by using nano text editor:
# nano /etc/network/interfaces
It would have a section for wlan3 that looks like shown below:
# auto wlan3 iface wlan3 inet dhcp wpa-ssid YourSSIDname wpa-psk YourWPAkey
Edit the wpa-ssid and wpa-psk with the values of your network.
After you are done press 'shift' + 'o' to save. Then press 'shift' + 'x' to exit the nano editor.
Then write:
# ifup wlan3
To enable the interface.
If the interface doesn't yet start, reboot the board.